Ligation

Correct answer: A. Ligation may be difficult

Successful ligation requires vector and insert ends that can align appropriately and present compatible chemical termini. With compatible sticky ends, complementary bases can pair, bringing the DNA fragments together so DNA ligase can seal the remaining phosphodiester backbone interruptions. If the ends are not compatible, this alignment and joining become inefficient or may fail, so option A is correct. The fragments may need to be re-cut with a suitable restriction enzyme, blunted and repaired, or joined by another cloning strategy. Non-compatible ends do not make ligation automatically perfect, and they cannot transform DNA into chlorophyll or water. The key concept is compatibility of DNA ends before ligase-mediated joining.

Correct answer: A. They lack complementary overhangs

The governing concept is end compatibility during DNA ligation. Sticky ends carry short single-stranded overhangs that can base-pair with a complementary overhang on another DNA molecule. This temporary pairing holds the ends together in the correct alignment, allowing DNA ligase to seal the phosphodiester backbone efficiently. Blunt ends have no such exposed complementary bases, so two DNA molecules must collide and remain aligned without base-pairing assistance. Ligase can join blunt ends, but the reaction is generally less efficient and may need optimized conditions or a higher DNA concentration. Blunt ends are still DNA, not proteins, and they are not necessarily methylated.

Correct answer: A. When the original site no longer cuts after ligation

The governing concept is diagnostic restriction analysis of a recombinant junction. When an insert and vector are joined, the two DNA ends may create a new sequence that no longer contains the original restriction-enzyme recognition site. A diagnostic digest can exploit this change: the expected clone is cut differently from an unligated or empty vector, producing a distinguishable band pattern on a gel. Comparing the observed pattern with predicted fragment sizes can therefore support confirmation of the desired construct. The useful event is not DNA absence, protein formation, or lack of a ladder; it is loss of the original cutting site after ligation.

Correct answer: A. To remove residual buffer, enzyme, salts, and unwanted small DNA fragments

After restriction digestion, the vector preparation may contain enzyme, salts, buffer components, glycerol, undigested molecules, and small unwanted fragments. Some of these substances can interfere with DNA ligase activity or with the correct joining of vector and insert. Purification, often by a cleanup column or gel extraction when size selection is required, gives cleaner DNA and can remove an unwanted small fragment or the original undigested vector. The purified vector ends are then supplied to the ligation reaction in a more suitable buffer and concentration. Option A is correct. Purification does not make a vector produce protein, turn agarose into water, or permanently activate a restriction enzyme, so B, C, and D are incorrect.

Correct answer: A. Recovery and quantification can be difficult

The governing concept is that DNA fragments must first be recovered and measured accurately before ligation. A very small fragment may migrate close to the dye front or diffuse during electrophoresis, making its band difficult to see. During gel extraction, it can also be lost through inefficient binding, transfer, or elution. Because the recovered amount is uncertain, the insert-to-vector molar ratio cannot be set reliably; too little insert may reduce recombinant formation, whereas excess insert may promote unwanted products. Therefore option A is correct. A small fragment does not become a protein, enzymes do not simply vanish, and the vector is not necessarily absent. Careful gel conditions, sensitive visualization, and quantitative measurement help reduce the problem.

Correct answer: A. The insert can ligate in both directions

The governing concept is end compatibility. When the vector and insert are cut with the same restriction enzyme, their corresponding ends are usually identical and compatible on both sides. The insert can therefore attach with either end facing either vector end, producing two possible orientations. If the gene has directional promoter, coding, or termination requirements, the reverse orientation may be nonfunctional even though ligation has occurred. Option A is correct. The insert is DNA, the vector necessarily has cut ends after digestion, and a restriction enzyme is not the same as DNA ligase. Directional cloning with two different restriction enzymes can reduce this ambiguity, but the final construct should still be confirmed by diagnostic digestion, PCR, or sequencing.